2-shot moulding technology

Using the 2-shot moulding technology, two different kinds of plastic can be processed in a single tool simultaneously. The benefits are obvious – using different materials, differing functions can be completed in a single construction module. In the process, our tools enable us to realise both hard/hard and hard/soft combinations. The possibilities range from extruded seals to two-component MID modules.

2-shot MID-demonstrator

2-shot plastic part with 3-dimensionally arranged, super-fine circuit board structures
PCB track widths of up to 100μm, with a high aspect ratio
hard/hard combination in LCP/LCP
Test platform for AVT processes such as wire bonding, flip-chip, SMD and press-in technology

conical nipple

2-shot plastic part as hard/soft combination in PA/TPE seal with an extruded back-up ring/bearing ring replaces two separated building components with a subsequent installation step.
application: industrial connector

2-shot plastic part

2-shot plastic part with 3-dimensionally arranged, complex circuit board structures
Sensor carrier for multiple ICs
Surfaces bondable using thin-wire technology
Application: Automotive industry

Close Window